In the surface, the 100-micro F capacitor is added to the empty pattern. The back has attached 108 laminating ceramic condensers of a 2.2-micro F tip to the portion of middle. Moreover, the laminating ceramic condenser of 1.5 micro F and some small capacity is also attached to the reverse side of a surface electrolysis capacitor etc.

Although it was a performance, a clock rise performance was not improved dramatically. (This is completely failure)

It was manufacturing, before putting "Overclocking DIY House" on the market. Although SW, Light Emitting Diode, and the speaker were put on the printed circuit board at first and rolled in the box, one notices what is necessary being just to put directly, and it makes.

SW of a C-MOS clearance is as convenient as unexpected. It is because a main board runsrecklessly fairly frequently and it is necessary to clear C-MOS.

The parts which are both pins are used between BIOS Savior and a socket, and it has not soldered only to a socket at BIOS Savior. Although it should escape if it pulls since it has not soldered, it does not separate, even if it puts in power. The switch is attached although a photograph is in a change portion also upwards. (It escapes from this perfectly)

Naturally -- 2M and 1M -- both -- having made.